CRU DE75 ATA/133 - Manual

Rugged, Reliable, Mobile, Secure
TM
1-800-260-9800 www.CRU-DataPort.com
Data Express DE75 ATA 133 Install Guide
Removable Ultra ATA133 Drive Enclosure
Drive Installation Overview
Receiving Frame Motherboard
Receiving Frame Motherboard (Rear View)
Receiving Frame Motherboard
DC Power Connector (P1): The Data Express uses a standard
4-pin DC Power Connector to accept DC power.
I/O Connector (JP1): The input/output connector provides a
standard interface for all IDE signals.
JP6 Header:
Master/Slave Setting (JP6 ID0 & ID1):
ID0: Jumper installed on Pins 1 & 2 (Factory Default) for
Master configuration.
ID1: Jumper installed on Pins 3 & 4 for Slave configuration.
Remote Drive Activity (JP6 RLED): Pins 17 & 18 are used for
remote drive activity.
Jumper (JP6 DDA): Factory-installed on Pins 15 & 16 - Do not
remove!
JP4 Option: Refer to the full version of the DE75i-A100 Manual
for further information.
Master/Slave Drive Selection
There are two (2) ways to set the Master/Slave drive designation
for the DE75i-A100 unit.
Method 1 (Recommended)
Using the factory-installed jumper on your IDE drive
In most cases, the drive will be factory-configured as a Master
Ultra ATA133 drive using a jumper plug on the drive itself. No
configuration changes are required. For multiple drive configura-
tions, it is necessary to set the first IDE drive as Master and the
second IDE drive to Slave. This can be done by changing the
jumper on the Ultra ATA133 drive itself (refer to your drive manu-
facturer documentation).
This method requires no additional configuration of the drive car-
rier circuit board.
Drive Installation Overview
Drive
Carrier
#6-32 x 3/16
Flat HD Screw
(6 Total)
I/O Cable
Drive
(Not Included)
Protective
Drive Cover
(Provided)
Power Cable
Receiving Frame
Motherboard
DC Power
Connector
I/O Connector
JP4 Option
Jumper (Do not remove)
ID0 } Master/Slave
ID1 Configuration
= Pin 1