CONTA-CLIP GSM-PRO Portal - Manual (Page 16)

GSM-PRO PORTAL
- 15 -
5.1.2 Broadcast
To perform a broadcast message right click “Modules” and select “Create broadcast”. Here it’s possible to select
an action per output:
• set to 1
• set to 0
• toggle
• set one shot (sec)
If an action is set for the required output the LED on the screen is red and the action is mentioned beneath it.
Press the broadcast button to send:
It is possible to send a broadcast message to a selected group of users. In the data-grid select one or multiple
rows, right click on one of them or right click “modules” and select “create broadcast”. If you now create a
message and press the broadcast button it is only send to the selected modules. In the example below the
message is send only to number 1, 3, 5, and 7:
5.2
Other Functions
5.2.1 Firmware update
The Portal can give a command to the module to activate the OTA(Over The Air) firmware update. This can be
given to one module or by (selected) broadcast.
To update one module right click the selected module and select “FOTAP”.
To update all or a selected group of modules (see chapter 5.1.2) right click “modules” and select “FOTAP all”.
See the GSM-PRO manual for further information on the Over The Air Firmware update.