CIRCUTOR CIRe3 Series - Manual (Page 39)

CIR-e 3
Instructions manual Pag. 39 of 50
Fig. 6-37.- Parameters selection menu
Filter type: Menu used to filter the displayed information. There are two options, as shown on
Fig. 6-38 : Standard or harmonics.
Fig. 6-38.- Filter types
6.10.3.1 Standard filter type:
The standard filter allows the individual selection of any of the recorded or calculated variables.
To select the desired set of variables, use the drop-down menu of Fig. 6-39. If only one variable
is selected you will get the same result as if you select the “Zoom” tool (see section 6.10.5.)
Fig. 6-39.- Variables selection menu
The selection menu with the standard filter option allows a wide choice of variables. The user
can select variables of a specific phase or all of them. The variables may be the instantaneous
values, maximum and/or minimum values or three-phase values, as shown on Fig. 6-40.
Fig. 6-40.- Specific variable selection