CIRCUTOR CIRe3 Series - Manual (Page 16)

CIR-e 3
Pag 16 of 50 Instructions manual
Equipment manufactured before 2012 have a built in rechargeable battery to
supply the internal clock. In case that the battery is discharged, the equipment
will lose the date and time and the records are done with the default date
01/01/2011 00:00 h. Please review the equipment date and time before
performing a measurement and recording operation. After a long period of
inactivity connect the equipment 12 hours before starting the records in order
to charge the battery.
All equipment manufactured in 2012 or later have a non rechargeable battery.
In this case replace the battery every 5 years.
6 INSTALLATION AND COMISSIONING
CIR-e³ is a portable analyzer that is easy to install and use. It has been designed to facilitate the
work of the companies and/or persons that wish to perform energy audits (study of
consumption) and control the main electrical parameters in an installation.
The study of these parameters is the first step to analyze the response of loads and the
consumption habits of a company or corporation. Without a doubt, the decisions taken after the
study can be focused on a more rational consumption of energy and a decrease in the power
demand of the electricity network.
The unit is configured from the PC with the SD card supplied with the unit. After selecting the
scale desired for the current sensors (in case of flexible clamps), make sure that all voltage and
current connections are correct so that the unit is ready to take measurements and record data.
Fig. 6-1.- Ten steps to set-up of CIR-e 3
Please follow the instructions described below to configure, install and commission the unit.