CIRCUTOR CIRe3 Series - Manual (Page 25)

CIR-e 3
Instructions manual Pag. 25 of 50
The software automatically will create the file xxxxxxxx.xst in the root directory of the SD card
(or in the selected default directory). The filename uses the last 8 digits of the serial number of
the unit, entered in the setup menu. The file includes the unit's configuration and installation's
characteristics, as shown on the following figure. The unit will take this configuration from the
SD card each time it starts measuring and recording.
Fig. 6-14.- File containing the configuration data
If the configuration file does not exist, or it is not stored it in the root directory of the SD card or
the CIRe³ analyzer can not find the SD memory card before the parameter recording process
starts, it will automatically load a default setup file called “Default”, which is loaded from the
analyzer. The default parameters are described in Fig. 6-15.
Fig. 6-15.- Default configuration parameters
Serial number: The serial number of the setup file is the unit's serial number.
Report name: The name of the report is “Default”.
Register period: The default recording period is 15 minutes
Voltage input data:
Primary voltage: The transformer's primary value is 1 (direct measurement)
Secondary voltage: The transformer's secondary value is 1 (direct measurement)
Select the current transformer ratio
Current transformer primary: Is not enabled in the Default configuration.
Nominal voltage (Ph-N): The standard nominal voltage is 230 Vac
Nominal Freq.: The standard frequency is 50 Hz.
Contracted power (kW): The default file does not include the contracted power