Denon S-301 User Manual

Page 48

ENGLISH

Advanced Operation

ENGLISH

ON/STANDBY

FUNCTION

CURSOR

ENTER

TONE/SDB

Press the

TONE/SDB

button.

• The tone switches as shown below each time the

TONE/SDB button is pressed.

BASS

SDB

(ON/OFF)

DEFEAT

TREBLE

With the name of the item to be adjusted
selected, press the

CURSOR

0 or 1 button to

adjust the level.

BASS, TREBLE:
• To increase the bass or treble:

Press the CURSOR

button. (The bass or treble sound can be

increased to up to +10 dB in steps of 2 dB.)

• To decrease the bass or treble:

Press the CURSOR

button. (The bass or treble sound can be

decreased to up to –10 dB in steps of 2 dB.)

When TONE/SDB is displayed, the item can be switched
pressing the CURSOR • or

button, and TONE/SDB button.

If no operation is performed within 4 seconds, the display
switches back to what was previously displayed.

Adjusting the sound quality (TONE/SDB)

DEFEAT:

The signals do not pass through the SDB, bass and treble
adjustment circuits, providing higher quality sound.

SDB (Supper Dynamic Bass):

Press the CURSOR

button to select “ON” or “OFF”.

Setting SDB to “ON” makes for powerful bass sound.

Other functions

• When the

button is pressed while the power is in the

standby mode, the ADV-S301’s power turns on automatically,
and if a disc is loaded in the ADV-S301 the disc is played.

• The auto power on function also turns the power on when the

disc holder is opened while the ADV-S301 is in the standby
mode.

• This unit is equipped with a last function memory which stores

the input and output setting conditions as they were
immediately before the power is switched off.
This function eliminates the need to perform complicated
resettings when the power is switched on.

• The unit is also equipped with a back-up memory. This function

provides memory storage when the power switch is off and
with the power supply cord disconnected.

Auto power on function

System functions

Initialization of the microprocessor

When the indication of the display is not normal or when the
operation of the unit does not shows the reasonable result, the
initialization of the microprocessor is required by the following
procedure.

Press the

ON/STANDBY

switch to set the

standby mode, then unplug the set’s power
supply cord from the wall power outlet.

Hold the following

button and FUNCTION

button after 30 second, and plug the power
supply cord into the outlet.

Check that the entire display is flashing with an
interval of about 1 second, and release your
fingers from the 2 buttons.
The microprocessor will be initialized.

• If step 3 does not work, start over from step 1.
• If the microprocessor is reset, all the buttons and the setup

settings are reset to the factory default values.

ON/STANDBY