Denon S-301 - Manual (Page 39)

36
ENGLISH
Basic Operation Basic Operation
ENGLISH
4 Press the CURSOR • , ª , 0 0 or 1 1 button to set
the current time, then press the ENTER button.
5
Press the ENTER button to enter the setting.
• To check the current time when the regular display is displayed,
press the STATUS button once.
• The time can be displayed by pressing the STATUS button when
the power is in the standby mode. (When this is done, the set
is no longer in the low power consumption standby mode.)
When pressed twice while the time is displayed, the display
turns off and the set is put back in the low power consumption
standby mode (
page 59).
• The clock runs by synchronizing with the power supply
frequency. The time may be off by 2 to 3 minutes per month. If
so, reset the time.
3 Press the ENTER button twice to change the
current time.
Example: When the current time is set to “PM 7:30”
Setting the sleep timer
• The included remote control unit can be used to turn the power
to the standby mode after a maximum of 120 minutes. (Sleep
timer)
• Use this function to automatically switch the power to the
standby mode after a specific amount of time (minutes).
Example: To set the power to the standby mode in 50 minutes
according to the clock.
1
Select and play the desired function.
2
Press the SLEEP button.
• “120” is displayed and the “SLEEP” indicator flashes.
120
The display switches as follows each time the SLEEP button
is pressed:
90 120 60 50 30 40 20 10
“SLEEP” indicator off
3 When the “SLEEP” indicator is flashing, press
the
SLEEP button again until “50” is displayed.
• “50” is displayed and the “SLEEP” indicator flashes.
50
After 4 seconds, the display returns to as it was before the
sleep timer was set, and the “SLEEP” indicator stops
flashing, remaining lit. (This completes the sleep timer
setting.)
4 The power is set to the standby mode 50 minutes
later.
To turn the sleep timer off, press the SLEEP button
repeatedly until the “SLEEP” indicator turns off. The sleep
timer can also be turned off by press the ON/STANDBY
switch on the main unit or the remote control unit to turn the
entire system’s power to the standby mode.
• If the SLEEP button is pressed while the sleep timer is
operating, the setting returns to 120 minutes. Make the setting
over.
• If the sleep timer and everyday timer settings overlap, the sleep
timer has priority.
8:00p.m. 9:00p.m. 10:00p.m.
8:00p.m. 9:00p.m. 10:00p.m.
ON OFF
ON OFF
+
ON OFF
8:00p.m. 9:00p.m. 10:00p.m.
ON OFF
ON OFF
+
• Also, the everyday timer will not operate if its start time is set
within the time during which the sleep timer is operating.
Everyday timer
once timer setting
Sleep timer
setting
Timer operation
If the timers overlap like this, the timer operates as follows:
Everyday timer
once timer setting
Sleep timer
setting
Does not operate
Does not operate
• The remaining time of the sleep timer can be checked with
the STATUS button.