Optoma EH200ST - Manual (Page 60)

0
English
Appendices
Lamp Replacement Procedure:
1. Switch off the power to the projector by pressing the “ ” button on the remote
control.or.“ ” on the Keypad of the projector.
2. Allow the projector to cool down for at least 30 minutes.
3. Disconnect the power cord.
4. Unscrew the one screw on the cover.
5. Push up and remove the cover. 2
..Lift up the lamp handle. 3
7. Press on the both sides then lift up and remove the lamp cord. 4
8. Unscrew the one screw on the lamp module. 5
9. Lift up the lamp handle .and remove the lamp module slowly and carefully. 7
To replace the lamp module, reverse the previous steps.
10. Turn on the projector and reset the lamp timer.
Lamp Reset: (i) Press “Menu”  (ii) Select “OPTIONS”  (iii) Select .
“Lamp Settings” .(iv) Select “Lamp Reset”  (v) Select “Yes”.
 The screw on the
lamp cover and the
lamp cannot be
removed.
 The.projector.
cannot.be.turned.
on if the lamp
cover.has.not.been.
placed.back.on.the.
projector..
 Do.not.touch.the.
glass.area.of.the.
lamp. Hand oil can
cause the lamp to
shatter. Use a dry
cloth.to.clean.the.
lamp module if it
was accidentally
touched.
1
2
7
5
6
3
4
5