Powering on/off the projector, Powering on the projector, Installation – Optoma EH200ST User Manual
Page 17
7
English
Installation
Powering On/Off the Projector
Turn.on.the.
projector fi rst and
then.select.the.
signal.sources.
(*) Optional
accessory
Powering On the Projector
1. Remove the.lens.cap..
2.. Securely connect the power cord and signal cable. When
connected, the On/Standby LED will turn Amber..
3. Turn on the lamp by pressing “ ”.button.either.on.the.top.of.
the projector or on the remote. The On/Standby LED will now
turn.Green..
The startup screen will display in approximately 10 seconds.
The fi rst time you use the projector, you will be asked to
select the preferred language and power saving mode.
4. Turn on and connect the source that you want to display
on the screen (computer, notebook, video player, etc). The
projector will detect the source automatically. If not, push
menu button and go to “OPTIONS”.
Make.sure.that.the.“Source.Lock”.has.been.set.to.“Off”.
If you connect multiple sources at the same time, press the
“SOURCE” button on the Keypad or direct source keys on
the remote control to switch between inputs.
.Lens.Cap.
(
*
)
.
Power
2
or