Optoma EH200ST - Manual (Page 16)

English
Installation
To.turn.ON.3D.glasses.
Verify that 3D content is being sent to the projector and
signal is compatible with projector specifications.
Turn on the “3D Mode” (Off/DLP-Link/VESA 3D - depend-
ing on which type of glasses you are using) of the 3D
projector. The option is located in the “Display” section of
the projector OSD menu.
Turn on 3D glasses and verify image appears in 3D with-
out eyestrain.
If the image does not appear in 3D, please check 3D
device set up correctly to send out 3D image or not. Or
“SBS Mode” should turn on when input signal is 2D 1080i
side-by-side and repeat previous steps 1 ~ 4.
It may be necessary to use projector’s “3D Sync-Invert”
option to optimize your 3D experience. The option is
located in the “Display” section of the projector OSD menu.
To turn OFF 3D glasses: Press the “Power” button and
hold until the LED switches off.
For more detailed information, please refer to the 3D
glasses user’s guide, or manufacturer's Website.
.
2.
3.
4.
5.
.
7.
.
Using the 3D glasses
For more de-
tailed informa-
tion,.please.
refer.to.3D.
glasses user’s
guide.
