Altera 100G Development Kit, Stratix IV GT Edition - Manual (Page 73)

Chapter 2: Board Components 2–65
Power
September 2010 Altera Corporation 100G Development Kit, Stratix IV GT Edition Reference Manual
Table 2–42 lists the Ethernet RGMII interface component reference and manufacturing
information.
Power
The board power is provided through a laptop style DC power input. The input
voltage must be in the range of 14 V to 20 V. The DC voltage is then stepped down to
the various power rails used by the components on the board.
Power Switch
The slide switch (SW1) is the board power switch. Table 2–43 shows the connection of
this power switch.
Power Distribution System
A 14-V – 20-V DC input from the DC power jack (J1) powers up the development
board.
U66.41 Media dependent interface 2 (N) MDI_N2
LVCMOS
— J49.5
U66.39 Media dependent interface 2 (P) MDI_P2 — J49.4
U66.43 Media dependent interface 3 (N) MDI_N3 — J49.8
U66.42 Media dependent interface 3 (P) MDI_P3 — J49.7
Table 2–41. Ethernet RGMII Interface Pin Assignments, Signal Names and Functions (Part 2 of 2)
Board
Reference
Description
Schematic Signal
Name
I/O Standard
Stratix IV GT
Device Pin
Number
Other
Connections
Table 2–42. Ethernet RGMII Interface Component Reference And Manufacturing Information
Board
Reference
Description Manufacturer
Manufacturing
Part Number
Manufacturer
Website
U66 10/100/1000 Base-T Ethernet PHY
Marvell
Semiconductor
88E1111-B2-CAA1C000 www.marvell.com
J49
RJ-45 connector with integrated
magnetics Halo
Electronics, Inc.
HFJ11-1G02E www.haloelectronics.com
Table 2–43. Slide Switch Pin-Out (SW1)
Board
Reference
Description
Schematic
Signal Name
I/O Standard
Stratix IV GT
Device
Pin Name
Other
Connections
SW1
Power switch. Slide switch to ON position
to power on the board. Slide switch to OFF
position to power off the board.
RUN_SW_MAIN — — U9.A10