Altera 100G Development Kit, Stratix IV GT Edition User Manual
Page 49

Chapter 2: Board Components
2–41
Components and Interfaces
September 2010
Altera Corporation
100G Development Kit, Stratix IV GT Edition Reference Manual
lists the pin assignments for the SFP+ interface (SFPB) and their
corresponding schematic signal names and Stratix IV GT pin numbers.
lists the SFP+ interfaces component reference and manufacturing
information.
Table 2–31. SFP+ Interface (SFPB) Pin Assignments, Schematic Signal Names, and Functions
Board
Reference
Description
Schematic
Signal Name
Stratix IV GT
Device
Pin Name
Other
Connections
J31.8
Signal loss indicator from the SFP+ interface
SFPB_LOS
U44.AL34
—
J31.6
Module present indicator from the SFP+
interface
SFPB_MOD0_PRSNTN
U44.AN38
—
J31.5
Two-wire serial interface clock line
SFPB_MOD1_SCL
U44.AP35
—
J31.4
Two-wire serial interface data line
SFPB_MOD2_SDA
U44.AP36
—
J31.7
Rate select 0. Controls the SFP+ interface
receiver. When input signaling is high, the
rate is > 4.25 GBps and when input signaling
is low, the rate
4.25 GBps.
SFPB_RATESEL0
U44.AT37
—
J31.9
Rate select 1. Controls the SFP+ interface
transmitter. When input signaling is high,
the rate is > 4.25 GBps and when input
signaling is low, the rate
4.25 GBps.
SFPB_RATESEL1
U44.AT38
—
J31.12
Received data (output from SFP+ interface)
SFPB_RX_N
U44.A7
—
J31.13
Received data (output from SFP+ interface)
SFPB_RX_P
U44.B7
—
J31.19
Transmitted data (input to SFP+ interface)
SFPB_TX_N
U44.C8
—
J31.18
Transmitted data (input to SFP+ interface)
SFPB_TX_P
U44.D6
—
J31.3
Turns off and disables the transmitter laser
output
SFPB_TXDISABLE
U44.AR37
—
J31.2
Interface transmitter fault
SFPB_TXFAULT
U44.AM33
—
Table 2–32. SFP+ interfaces Component Reference And Manufacturing Information
Board
Reference
Description
Manufacturer
Manufacturing
Part Number
Manufacturer
Website
J31, J32
SFP+ connector
Samtec
MECT-110-01-M-D-RA1
U32
Single port 10-Gbps bidirectional EDC
soft clock data recovery (CDR)
Vitesse
VSC8240XIB-01