Altera DSP Development Kit, Stratix V Edition - Manual (Page 22)

4–6 Chapter 4: Development Board Setup
Factory Default Switch Settings
DSP Development Kit, Stratix V Edition July 2013 Altera Corporation
User Guide
5. Set DIP switch bank (SW6) to match Table 4–5 and Figure 4–2 .
f For more information about the FPGA board settings, refer to the DSP Development
Kit, Stratix V Edition Reference Manual .
Table 4–5. SW6 DIP Switch Settings
Switc
h
Board
Label
Function
Default
Position
1
PCIE_PRSNT2
n_x1
Switch 1 has the following options:
■ When on (0), x1 presence detect is enabled.
■ When off (1), x1 presence detect is disabled.
On
2
PCIE_PRSNT2
n_x4
Switch 2 has the following options:
■ When on (0), x4 presence detect is enabled.
■ When off (1), x4 presence detect is disabled.
On
3
PCIE_PRSNT2
n_x8
Switch 3 has the following options:
■ When on (0), x8 presence detect is enabled.
■ When off (1), x8 presence detect is disabled.
On
4 — — Off