Altera Arria V GX FPGA - Manual (Page 19)

Chapter 4: Development Board Setup 4–5
Factory Default Switch and Jumper Settings
July 2012 Altera Corporation Arria V GX FPGA Development Kit
User Guide
5. Set DIP switch bank (SW8) to match Table 4–5 and Figure 4–2 .
6. Set the board jumpers to match Table 4–6 , Figure 4–1 and Figure 4–2 .
Table 4–5. SW8 FPGA1 MSEL Dip Switch Settings (1)
Switch
Board
Label
Function
Default
Position
1 FPGA1_MSEL[1]
Switch 1 has the following options:
■ When ON, a logic 0 is selected.
■ When OFF, a logic 1 is selected.
ON
2 FPGA1_MSEL[2]
Switch 2 has the following options:
■ When ON, a logic 0 is selected.
■ When OFF, a logic 1 is selected.
OFF
3 — — ON
4 FPGA1_MSEL[4]
Switch 4 has the following options:
■ When ON, a logic 0 is selected.
■ When OFF, a logic 1 is selected.
OFF
Note to: Table 4–5
(1) Ensure that all MSEL setting are in a defined configuration scheme as shown in Volume 2: Device Interfaces and
Integration of the Arria V Device Handbook.
Table 4–6. Jumper Settings (Part 1 of 2)
Board
Reference
Board
Label
Function
Default
Position
J5 FMC_VCCPD
This jumper has the following options:
■ Installing the shunt on pins 1-2 provides 2.5 V on
FMC_VCCPD.
■ Installing the shunt on pins 2-3 provides 3.3 V on
FMC_VCCPD.
Pins 1-2
J11 FMC_VCCIO_SEL
This jumper has the following options:
■ No shunt = 1.5V
■ Shunt on pins 1-2 = 1.8V
■ Shunt on pins 3-4 = 2.5V
■ Shunt on pins 5-6 = 3.3V
Note: When setting this jumper to 3.3 V, make sure
the FMC_VCCPD is on the correct setting (J5 shunt
on pins 2-3).
Pins 3-4
J14 FAN2 Powers the fan for FPGA 2 Installed