Altera Arria V GX FPGA - Manual (Page 14)

3–4 Chapter 3: Software Installation
Installing the USB-Blaster II Driver
Arria V GX FPGA Development Kit July 2012 Altera Corporation
User Guide
Installing the USB-Blaster II Driver
The Arria V GX FPGA development board includes integrated On-Board USB-Blaster
II circuitry for FPGA programming. However, for the host computer and board to
communicate, you must install the USB-Blaster II driver on the host computer.
f
Installation instructions for the USB-Blaster II driver for your operating system are
available on the Altera website. On the
Altera Programming Cable Driver Information
page of the Altera website, locate the table entry for your configuration and click the
link to access the instructions.
f For USB-Blaster II configuration details, refer to the On-Board USB-Blaster II page.