Altera Arria V GT FPGA - Manual (Page 43)

Chapter 6: Board Test System 6–21
Using the Board Test System
November 2012 Altera Corporation Arria V GT FPGA Development Kit
User Guide
The SMA Tab
The SMA tab ( Figure 6–9 ) allows you perform loopback tests on the SMA port .
The following sections describe the controls on the SMA tab.
Status
The Status control displays the following status information during the loopback test:
■ PLL lock —Shows the PLL locked or unlocked state.
■ Channel lock —Shows the channel locked or unlocked state. When locked, all
lanes are word aligned and channel bonded.
■ Pattern sync —Shows the pattern synced or not synced state. The pattern is
considered synced when the start of the data sequence is detected.
Figure 6–9. The SMA Tab