Altera Arria V GT FPGA - Manual (Page 20)

4–6 Chapter 4: Development Board Setup
Factory Default Switch and Jumper Settings
Arria V GT FPGA Development Kit November 2012 Altera Corporation
User Guide
f For more information about the FPGA board settings, refer to the Arria V GT FPGA
Development Board Reference Manual .
J28 FMC_VCCIO_SRC
This jumper has the following options:
■ Installing the shunt on pins 1-2 powers bank 4B
when there is no FMC card installed or the FMC
card does not provide a voltage for this rail. The
voltage on this depends on the voltage selected on
J11.
■ Installing the shunt on pins 2-3 powers bank 4B
when an FMC card is installed and provides the
power needed for this bank. The max voltage on
this is 3.3 V. Do not install an FMC with a higher
rated card.
Note: FMC is not available for rev. A boards.
Pins 1-2
J23 FAN1 Powers the fan for FPGA 1. Installed
Table 4–6. Jumper Settings (Part 2 of 2)
Board
Reference
Board
Label
Function
Default
Position