Altera Cyclone III FPGA Starter Kit - Manual (Page 21)

Altera Corporation 3–7
July 2010 Cyclone III FPGA Starter Kit User Guide
Using the Control Panel
Read/Write Data
To read from and write to the flash memory, follow these steps:
Figure 3–5. Control Panel Flash Memory Tab
1. Click Erase Block to perform a block erase of the flash memory. The
Address
column indicates the hex address of the flash memory. The
values inside the 0-3, 4-7, 8-B, and C-F columns are the flash
memory contents in hex words format.
2. To write a 32-bit word to the flash memory, click the desired
location, enter the desired value in hex format, and press Enter.