Altera User Flash Memory - Manual (Page 29)

Figure 9: ModelSim-Altera Software Simulation Waveforms
ALTUFM_PARALLEL Ports
Input Ports
Table 22: ALTUFM_PARALLEL Input Ports
Comments Description Required Port Name
Input port [WIDTH_
ADDRESS-1..0] wide.
The add port is used
with the parallel
interface protocol only.
(1)
Address bus. Yes
addr[]
Input port [WIDTH_
DATA-1..0] wide.
(1)
Data bus input. Yes
di[]
When the ACCESS_
MODE parameter is set
to READ_ONLY, the
nerase port cannot be
used.
(1)
Erase input port. No nerase
(1) Read input port. Yes nread
(1) Write input port. No
nwrite
Note to Table 3–5:
1. This port is used with the parallel interface protocol only.
Altera Corporation Altera User Flash Memory (ALTUFM) IP Core User Guide
Send Feedback
29 ALTUFM_PARALLEL Ports
UG-040105
2014.08.18