Pilz PSSu E S ABS SSI - Manual (Page 29)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
6-1
6.1 General wiring guidelines
6 Wiring
6 6000 Wiring Wiring 6- 6.1 General wiring guidelines 6100 General wiring guidelines 6- ][Verdrahtung BA Einleitung
Please note:
][Verdrahtung ST ABS SSI  Use twisted pair cables to carry the differential signals (D+/D- and
Cl+/Cl-). This will increase the noise immunity.
 Use shielded signal cables with metallic plugs.
 On base modules with C-rail:
– Connect the shield to the terminals on the C-rail.
– Connect the C-rail with low impedance to the functional earth.
 On base modules without C-rail:
– Connect the shield as shown in the terminal configuration section.
The module connects the shield to the mounting rail.
– Connect the mounting rail to the functional earth via an earthing
terminal.
 The supply voltages must be extra low voltages with safe electrical
separation (PELV or SELV) in accordance with VDE 0100, Part 410.
 Use copper wiring.
][Verdrahtung Zusatz mit C  The terminal configuration as stated on the front plate applies for base
modules with C-rail. The terminal configuration as stated in the tech-
nical documentation applies for all other base modules.
6.1.1 Mechanical connection of the base modules
Mechanical connection of the base modules 6- ][Modulverdrahtung mech
Procedure:
 Use a flat blade screwdriver (DIN 5264-A)!
 Strip the wire back 8 mm.
 If necessary, label the connection level with a colour marker [3].
 Base module with screw terminals:
– Use a screwdriver to loosen the screw on the screw terminal [1]
– Insert the stripped cable into the round fixing hole [2], as far as it
will go.
– Tighten up the screw on the screw terminal.
– Check that the cable is firmly seated.
DIN 5264-A