Pilz PSSu E S 4DI - Manual (Page 19)

Wiring
Operating Manual PSSu E S 4DI(­T)
21340­EN­06 19
6 Wiring
6.1 General wiring guidelines
Please note:
} Signal lines do not have to be shielded.
} Use copper wiring.
} The terminal configuration as stated on the front plate applies for base modules without
C­rail. The terminal configuration as stated in the technical documentation applies for all
other base modules.
6.1.1 Mechanical connection of the base modules
Procedure:
} Use a flat blade screwdriver (DIN 5264­A)!
DIN 5264-A
} Strip the wire back 8 mm.
} If necessary, label the connection level with a colour marker [3].
} Base module with screw terminals:
– Use a screwdriver to loosen the screw on the screw terminal [1]
– Insert the stripped cable into the round fixing hole [2], as far as it will go.
– Tighten up the screw on the screw terminal.
– Check that the cable is firmly seated.
} Base module with cage clamp terminals:
– Insert the screwdriver [4] into the square hole [1].
– Insert the stripped cable into the round fixing hole [2], as far as it will go [5].
– Pull out the screwdriver [6].
– Check that the cable is firmly seated.