Pilz PNOZ mc12p Powerlink - Manual (Page 11)

Installation
Operating Manual PNOZ mc12p
1003016-EN-01
11
Installation
General installation guidelines
} The control system should be installed in a control cabinet with a protection type of at
least IP54. Fit the control system to a horizontal mounting rail. The venting slots must
face upward and downward. Other mounting positions could destroy the control system.
} Use the notches on the rear of the unit to attach it to a mounting rail. Connect the con-
trol system to the mounting rail in an upright position, so that the earthing springs on the
control system are pressed on to the mounting rail.
} The ambient temperature of the PNOZmulti units in the control cabinet must not exceed
the figure stated in the technical details, otherwise air conditioning will be required.
} To comply with EMC requirements, the mounting rail must have a low impedance con-
nection to the control cabinet housing.
ATTENTION!
Damage due to electrostatic discharge!
Electrostatic discharge can damage components. Ensure against discharge
before touching the product, e.g. by touching an earthed, conductive surface
or by wearing an earthed armband.
Dimensions
94 (3.70") 22,5
(0.88")
114 (4.49")
Connecting the base unit and expansion modules
You can install a maximum of 1 PNOZ mc12p to the left of the base unit.
} Do not connect a terminator to the last expansion module on the left-hand side.
} Install the expansion module in the position in which it is configured in the PNOZmulti
Configurator.
5
5.1
5.2
5.3