Pilz PNOZ mc7p CC-Link coated version - Manual (Page 14)

Operation
Operating Manual PNOZ mc7p
1003050-EN-01
14
Operation
When the supply voltage is switched on, the PNOZmulti safety system copies the configu-
ration from the chip card.
The LEDs "POWER","DIAG", "FAULT", "IFAULT" and "OFAULT" light up on the base unit.
The expansion module
PNOZ mc7p is configured and started automatically.
Messages
Legend:
LED on
LED off
LED Meaning
RUN Green Bus connection present
} Bus connection is not available
} Status: timeout
} No supply voltage at the fieldbus module PNOZ mc7p
L Err Red Fault detected: Wrong station address or transmission rate
} Bus connection present
} No supply voltage at the fieldbus module PNOZ mc7p
RD Green PNOZ mc7p Receiving data
} PNOZ mc7p Not receiving data
} No supply voltage at the fieldbus module PNOZ mc7p
SD Green PNOZ mc7p Sending data
} PNOZ mc7p Not sending data
} No supply voltage at the fieldbus module PNOZ mc7p
7
7.1