Dukane ULTRASONIC GENERATOR/POWER SUPPLY LS 403-574-01 - Manual (Page 96)

Page 0
iQ Series ,
Ultrasonic Generator/Power Supply LS User’s Manual
Dukane Manual Part No. 403-574-01
J2
U/S
I
0
LINE VOLTAGE:
200-240 Vac
50/60Hz, 15A
PE
J3
J4
J1
BUS ERROR
PROFIBUS
J16
iQ LinQ
™
PROFIBUS Communications Module
Part Number - 110-4554
The PROFIBUS option module allows the iQ generator
to connect to a PROFIBUS network. Since PROFIBUS
is multipoint instead of point-to-point, more than one
generator can be connected to a single bus cable. The
PROFIBUS module offers access to generator parameter
settings and status information listed below. In addition,
if desired, all I/O wiring can be replaced with a single
PROFIBUS cable.
Control Parameters available via PROFIBUS
1. Set weld method to Time, Energy, or Peak Power. Set
associated values in seconds, joules, or watts.
2. Set Amplitude, Ramp Up Time, and Ramp Down
Time.
3. Enable and set Trigger by Power parameters.
4. Enable and set Hold Time.
5. Enable and set Afterburst delay and duration.
6. Enable checking for Suspect Parts. Set maximum and
minimum values for Time, Power and/or Energy.
7. Enable checking for Bad Parts. Set maximum and
minimum values for Time, Power and/or Energy.
8. Configure advanced hardware settings including
Phase, Free Run Frequency, Frequency Lock and
Hold, and Frequency limits.
Parameters that can be obtained via PROFIBUS
1. All parameters that are configured via PROFIBUS
2. Real time data which includes welder state (ultrasound
active or not), frequency, power, and amplitude.
3. Weld cycle data from previous weld which includes:
• Cycle Count
• Good, Bad, and Suspect Part information
• Process Limit setting exceeded or not reached if Bad
or Suspect Part checking is enabled
• Weld Time
• Weld Energy (Time and Energy option)
• Peak Power
For information on how to control and/or monitor specific
parameters, iQ Generator PROFIBUS Communication and
Control documentation is available.
Signing a non-disclosure agreement is required to obtain this
documentation.
Figure 10-20 PROFIBUS Communications Module
PROFIBUS
Module
Bus error activates LED (Red)