Dukane ULTRASONIC GENERATOR/POWER SUPPLY LS 403-574-01 - Manual (Page 44)

Page 3
iQ Series ,
Ultrasonic Generator/Power Supply LS User’s Manual
Dukane Manual Part No. 403-574-01
Control Keys
Keys Left of the Display
INFO
After the primary weld method has been chosen, you
can press the INFO key to go directly to the “Hot Key”
screen where frequently used menus can be accessed. In
the screens shown here, Energy is the weld method.
Use the up and down navigation keys,
to move the selection indicators,
,
to the desired selection. Press ENTER to proceed.
ON/OFF Line
The ON/OFF LINE key is used to deactivate the
ultrasonic signal. For example, select OFFLINE during
your process setup or to cycle the assembly equipment
without ultrasound activated.
Keys - Right of Display
Keys - Left of Display
LOAD
80 60 100
OVER
40 0 20
SYSTEM POWER OUTPUT LEVEL
SYSTEM OPERATING MODE
ON
LINE
OFF
LINE
POWER
TEST
# 1 PART COUNT 125
WELD TIME 0.080 S
POWER 1050 W
ENERGY 350 J
INF
O
O
N
/O
FF
LIN
E
TE
ST
C
AN
CE
L
ENT
ER
Figure 5 - 2 Front Panel Control Detail
Navigation Keys (4)
WELD ENERGY HOTKEY
AMPLITUDE
PROCESS SETUP
SYSTEM INFO
Weld Method - Time, Energy, Power,
- programmed by the user.
Time is the default method.
Screen shown in Operate Mode.
Screen shown in Setup Mode.
WELD ENERGY HOTKEY
AMPLITUDE
OPERATE
SYSTEM INFO
SYSTEM INFO will give
the software version,
model number.
If a transducer is not connected to
the ultrasound output connector,
the system should be set to the
OFFLINE mode. Do not activate
the ultrasound output without a
transducer connected. Make sure
that the stack is properly assembled
before it is connected to the system.
The horn should never come in
direct contact with a metal fixture
or anvil with ultrasound activated.
CAUTION
