Power inlet options, Electrical safety – Dukane ULTRASONIC GENERATOR/POWER SUPPLY LS 403-574-01 User Manual
Page 79
Page 73
Section 10 - Options
Dukane Manual Part No. 403-574-01
This section of the User’s Manual provides a general
overview of some options/upgrades, all of which are sub-
ject to availability, for the basic ultrasonic generator:
Power Inlet Options
120V Systems for North America and
Japan
120V systems for North America and Japan have a fixed
(non-detachable) power cord.
This option is available on generators with power ratings
of 1200 watts or less and with operating frequencies of
20kHz, 30kHz, or 40kHz.
See Table 11-II in Section 11, Specifications.
Electrical Safety
120V Power Ground
For safety, the power cords used on all Dukane
products have a three-prong, grounding-type plug.
Approved 2 pole, 3 wire grounding
receptacle HUBBELL No. 5262 or equivalent
to NEMA 5–15R or 5–20R
Figure 10 - 1 Example of 120 Volt,
Grounded, 3-Prong Receptacle
CAUTION
If there is any question about
the grounding of your recep-
tacle, have it checked by
a qualified electrician. Do
not cut off the power cord
grounding prong, or alter
the plug in any way. If an
extension cord is needed,
use a three-wire cord that is
in good condition. The cord
should have an adequate
power rating to do the job
safely. It must be plugged
into a grounded receptacle.
Do not use a two-wire exten-
sion cord with this product.
CAUTION
If you have a two-prong elec-
trical receptacle, we strongly
recommend that you replace
it with a properly grounded
three-prong type. Have a quali-
fied electrician replace it fol-
lowing the National Electric
Code and any local codes
and ordinances that apply.