Stopping the weld cycle – Dukane ULTRASONIC GENERATOR/POWER SUPPLY LS 403-574-01 User Manual
Page 47
Page 41
Section 5 – Standard System Status and Controls
Dukane Manual Part No. 403-574-01
Stopping the Weld Cycle
Normal Conditions
The cycle stops when the programmed welding cycle
ends.
Emergency Conditions
Manual System
Press OFFLINE to stop the ultrasound signal. This
may be done under any condition.
Automated System
Customer-supplied external controls provide the
means to stop the cycle for an automated system.
An auxiliary cable connects these external controls
to the iQ generator at connector J2.
Control input labeled, “Automation Cycle Stop
Input” (Pin 15) when activated will stop the weld
cycle if configured as “End of Weld”.