Dukane ULTRASONIC GENERATOR/POWER SUPPLY LS 403-574-01 - Manual (Page 54)

Page 4
iQ Series ,
Ultrasonic Generator/Power Supply LS User’s Manual
Dukane Manual Part No. 403-574-01
Screen Navigation Basics
This section gives you a step-by-step guide to navigating
through some of the basic menu structure.
AMPLITUDE 50 %
FREE RUN FRQ 20000 Hz
OPERATE MODE
PROCESS DATA
PROCESS STATISTICS
SYSTEM PARAMETERS
PART COUNT 0
GOOD 0 0%
BAD
SUSPECT
0
0 0%
0%
OPERATE MODE
PROCESS DATA
PROCESS STATISTICS
SYSTEM PARAMETERS
OPERATE MODE
PROCESS DATA
PROCESS STATISTICS
SYSTEM PARAMETERS
1. Press CANCEL until you see the Main Menu screen
as it is shown here.
Selection indicator is on OPERATE MODE.
2. Press ENTER to view OPERATE MODE selections.
Selection indicator is on PROCESS DATA.
3. Press ENTER. The screen you see is the one that ap-
pears just after the generator is first switched ON.
4. After viewing this screen, press CANCEL once to
return to the OPERATE MODE menu.
5. Press the down arrow key, and select
PROCESS STATISTICS.
6. Press ENTER.
The next screen shows part statistics.
7. Press CANCEL to return to OPERATE MODE
selections.
8. Using the up and down arrow keys, select SYSTEM
PARAMETERS.
9. Press ENTER, and view the parameters.
10. Press CANCEL to return to OPERATE MODE
selections.
#1 PART COUNT
WELD TIME
POWER
ENERGY
_ _ _ _ _
0.000 S
0 W
0 J
OPERATE MODE
PROCESS DATA
PROCESS STATISTICS
SYSTEM PARAMETERS
Selection Indicator
# 1:
OPERATE MODE
PROCESS SETUP
HARDWARE SETUP
AMPLITUDE 50%
FREE RUN FRQ 20000 Hz
POWER 600 W
NOTE
POWER is added
to the parame-
ters display on “E
model” genera-
tors as shown in
the screen illus-
tration below.
AMPLITUDE 50%
FREE RUN FRQ 20000 Hz
POWER 60 W