Spectrum Controls 1746sc-CTR4 - Manual (Page 27)

Channel Configuration, Data,
and Status
Read this chapter to:
• configure each input channel
• set user-defined scale limits
• monitor each input channel
• check each output channel’s configuration and status
Configuring Each Input
Channel
The Data Register format uses Class 3 operation. Class 3 mode allows
the module to use 32 input words and 32 output words of data, as listed
below. After installing your module, you must configure each channel
by setting bit values in each configuration word. Output words 0 through
31 of the output image file (addresses O:e.0 – O:e.31) configure channels
0-7 respectively and (addresses O:e.0 - O:e.15) for channels 0 - 3 of the
CTR4.
Chapter 4