HITEC X1 MF: AC/DC, 80-Watt, Multi-Function, Charger - Manual (Page 6)

04
X1 MF
Data Store/Load
The charger can store up to 10 different charge/discharge profiles for
your convenience. Each profile can store settings for battery type and
charge/discharge parameters. You can easily recall these saved profiles
to increase simplicity and efficiency of common processes.
Termination Voltage Control
The end charge voltage can be adjusted for each type of battery
chemistry up to the maximum safe limit.
LiPo Battery Meter
Displays total battery voltage, each cell's voltage, and the highest and
lowest cell voltages.
Motor RPM Tester (see page 28 for details)
ESCs equipped with motor RPM sensor ports can connect to the X1 MF
to display real-time motor RPM.
Servo Tester (see page 29 for details)
The X1 MF can test most analog or digital servos by connecting them to
the servo/esc port on the charger and adjusting the pulse width value.
Re-Peak Mode of NiMH/NiCd Battery
In re-peak charge mode, the charger can peak charge the battery once,
twice or three times in a row automatically. This is good for making
certain the battery is fully charged, and for checking how well the battery
receives fast charges.
Delta-peak Sensitivity for NiMH/NiCd
Delta-peak charging for NiMH and NiCd batteries monitors the cells
voltage and terminates the charge when the pack reaches full capacity.
You can adjust the peak mV setting to either increase or decrease the
charger’s sensitivity to the voltage drop that occurs when the pack nears
full capacity. Note: a lower mV setting is more sensitive and will
terminate the charge process earlier than a higher mV setting.