HITEC X1 MF: AC/DC, 80-Watt, Multi-Function, Charger - Manual (Page 30)

29
X1 MF
SELECT
SELECT
This diagram shows the correct way to connect a servo to the X1 MF.
Note: the servo is driven by a lithium battery connected to the balancing board.
The X1 MF can test most digital and analog servos. To test for basic
servo functionality, please connect as follows:
1. Connect a lithium battery to the balancing board.
2. Connect your servo to the SERVO/ESC port on the X1 MF. Pay close
attention to the polarity: negative is farthest from the notch/key tab.
3. Turn the dial left and right to move the servo.
PROGRAM SELECT
SERVO TESTER
Negative
(black wire)
PULSE WIDTH
900uS
Press the dial once to enter the Servo Tester
Program
Adjust the pulse width by turning the dial left or right
to test servo functionality.