Hanna Instruments HI 3512 User Manual
Page 61
61
Data transmission from the instrument to the PC can be done with the
HI 92000 Windows
®
compatible software (optional).
HI 92000 also
offers graphing and on-line help feature.
Data can be exported to the most popular spreadsheet programs for
further analysis.
To connect your instrument to a PC, use an USB cable connector. Make
sure that your instrument is switched off and plug one connector to the
instrument USB socket and the other to the serial or USB port of your PC.
Note: If you are not using Hanna Instruments HI 92000 software,
please see the following instructions.
SENDING COMMANDS FROM PC
It is also possible to remotely control the instrument with any terminal
program. Use an USB
cable to connect the instrument to a PC, start the
terminal program and set the communication options as follows: 8, N, 1,
no flow control.
COMMAND TYPES
To send a command to the instrument follow the next scheme:
> where: Note: Either small or capital letters can be used. SIMPLE COMMANDS KF1 Is equivalent to pressing function key 1 KF2 Is equivalent to pressing function key 2 KF3 Is equivalent to pressing function key 3 RNG Is equivalent to pressing RANGE key CAL Is equivalent to pressing CAL key UPC Is equivalent to pressing the UP arrow key DWC Is equivalent to pressing the DOWN arrow key MNU Is equivalent to pressing MENU key ESC Is equivalent to pressing ESC key PC INTERFACE PC INTERFACE PC INTERFACE PC INTERFACE PC INTERFACE