Glow-worm Flue - Manual (Page 5)

0020095198_02 - 06/11 - Glow-worm
INTRODUCTION
- 5 -
flue clearances
The flues should be positioned so that at least the minimum
operational and servicing clearances are provided, refer to the
appropriate section of the installation literature supplied with
your appliance. Additional clearances may be beneficial for
installation and servicing.
For flue installations where external access is not practicable,
consideration should be given for the space required to insert
the flue internally, which may necessitate clearance larger than
those specified.
Timber frame buildings
If the flue is to be installed in a timber frame building it should
be fitted in accordance with the Institute of Gas Engineers
document IGE/UP/7/1998.
If in doubt seek advice from Glow-worm or the advice line for
registered gas installers provided by the body approved at the
time by the Health and Safety Executive.
combustible Material
The flue is suitable for installation onto and through combustible
materials provided that a minimum 5mm clearance is
maintained around the circumference of the flue (air intake).
1.3.1 local regulations
Benchmark places responsibilities on both manufacturers
and installers. The purpose is to ensure that customers are
provided with the correct equipment for their needs, that it is
installed, commissioned and serviced in accordance with the
manufacturer’s instructions by a competent person approved at
the time by the Health and Safety Executive and that it meets
the requirements of the appropriate Building Regulations.
The Benchmark Checklist can be used to demonstrate
compliance with Building Regulations and should be provided to
the customer for future reference.
Installers are required to carry out installation, commissioning
and servicing work in accordance with the Benchmark Code
of Practice which is available from the Heating and Hotwater
Industry Council who manage and promote the Scheme.
• Visit www.centralheating.co.uk for more information.