EXFO IQS-9100B Optical Switch for IQS-500/600 - Manual (Page 92)

SCPI Command Reference
86 IQS-9100/9100B
Product-Specific Commands—Description
:ROUTe[1..n]:SCAN:SYNChronous
Description This command enables/disables the switch to
change position synchronously or not.
Syntax :ROUTe[1..n]:SCAN:SYNChronous
hronous>
Parameter(s) Synchronous:
The program data syntax for is
defined as a element.
The special forms ON and OFF
are accepted on input for increased readability.
ON corresponds to 1 and OFF corresponds to 0.
The parameter enables or
disables the synchronous mode.
1 or ON, enables the synchronous mode for
changing position.
0 or OFF, disables the synchronous mode for
changing position.
Example(s) ROUT:SCAN:SYNC 0
ROUT:SCAN:SYNC? returns 0
ROUT:SCAN 12
STATUS? returns BUSY (Module busy)
See Also ROUTe[1..n]:SCAN
ROUTe[1..n]:SCAN?
ROUTe[1..n]:SCAN:SYNChronous?