EXFO FTB-7000 OTDR for FTB-200 v2 - Manual (Page 131)

Analyzing Traces and Events
OTDR 117
Displaying the Graph in Full Screen
Displaying the Graph in Full Screen
You can display the graph in full screen at any time, even when an
acquisition is underway. The graph will keep the same display options as in
normal view (grid, file name, zoom window, inverted colors).
You can start acquisitions directly (via the button located on the
front of your unit) without having to go back to normal view first. You can
switch from one wavelength to another.
The information that is displayed at the bottom of the graph depends on
the tab that was selected when you switched to full-screen mode. The
table below gives an overview of the information that is available in each
case.
As soon as a trace is displayed (new acquisition or existing file), zoom
controls are available (see Using Zoom Controls on page 123).
Note: If you want to use the zoom-on-event feature, you must select the
button from the Events tab before switching to full-screen mode.
Tab that was selected Displayed information in full-screen mode
OTDR Acquisition parameters (wavelengths appearing
on the list correspond to those that are selected in
the tab).
Events A table of events that can be viewed one event at a
time.
Measure Marker information and either the four-point event
loss, attenuation, reflectance, or ORL
measurement, depending on the type of
measurement that is selected in the tab.
Trace Info. No further information is displayed. Only the graph
is available.