Rt45 operator’s manual – Ditch Witch RT45 User Manual
Page 118
RT45 Operator’s Manual
Microtrenching - 119
Setup
CMW
®
Adjust Tilt
1.
Lower microtrencher and turn off tractor.
2.
Loosen 4 clamp bolts (2, and two on other
side of mount).
3. Adjust manual adjustment turn screw (1) and
watch bubble level (3) until desired tilt is
achieved.
4.
Tighten clamp bolts.
Adjust Level Indicator
1.
Shut down tractor and remove blade. (See
page 180.)
2.
Using lift control and level control, position
base of microtrencher flat on pavement.
3.
Loosen bolts (1) in adjustable link and align
moving pointer (2) with fixed pointer.
4.
Tighten bolts.
IMPORTANT: Microtrenching requires good
contact between the microtrencher frame and
the surface being cut. Use lift control, level
control, and manual tilt to adjust microtrencher
to match jobsite conditions.
- JT5 (161 pages)
- JT922 (159 pages)
- JT9 (165 pages)
- JT20 (195 pages)
- JT1220 (201 pages)
- JT2020 (203 pages)
- JT25 (203 pages)
- JT30 (245 pages)
- JT60 (218 pages)
- JT100 (243 pages)
- AT Air Hammer (11 pages)
- TK Series Manual (61 pages)
- 8500 (77 pages)
- MR90 (121 pages)
- FT5 (28 pages)
- FM5 (57 pages)
- FM13V (46 pages)
- FM25 (67 pages)
- P80 (71 pages)
- OnGrade (63 pages)
- FX20 (100 pages)
- FX25 (119 pages)
- FX30 (149 pages)
- FX50 (141 pages)
- FX60 (157 pages)
- MV800 (111 pages)
- RT Line (115 pages)
- RT30 (97 pages)
- RT55 (177 pages)
- RT100 (161 pages)
- RT115 (252 pages)
- RT120 (223 pages)
- Zahn (105 pages)
- RT80 (203 pages)
- RT115 Q (193 pages)
- RT120 Q (211 pages)
- 100SX (50 pages)
- 410SX (131 pages)
- SK350 (77 pages)
- SK750/SK755 (81 pages)
- SK850 (107 pages)
- SK850 Footings Machine (107 pages)
- 150RT (55 pages)
- 250RT (49 pages)