Start unit, Standard procedure, Fx50 operator’s manual – Ditch Witch FXT50 User Manual
Page 57
Vacuum and Pothole - 56
FX50 Operator’s Manual
Start Unit
CMW
Start Unit
Standard Procedure
1.
Open tank inlet valve.
2.
If equipped with reverse flow, ensure vacuum is in “vacuum” mode before starting.
3.
Insert key.
4.
Turn key clockwise.See page 24 for more information.
5.
Run engine at low throttle for 5 minutes.
EMERGENCY SHUTDOWN: Turn ignition switch to STOP.
IMPORTANT: If power pack is not connected to external tank control
valves, connect a -04 hose with a minimum working pressure rating of
3000 psi (207 bar) from pressure (1) to power beyond (2) connections
on power pack.
NOTICE: Avoid idling engine with inlet valve closed.
NOTICE: If engine turns but does not start within 10 seconds, allow starter to cool before trying to
start engine again.
j36om006w.eps