Cino FA470 - Manual (Page 9)

Command Overview
1-2
1.1 Command Briefing
The FuzzyScan Serial Commands provide a simple and effective way for serial host
application to communicate with FuzzyScan device with ease. All commands have been
categorized into several functional groups, including “Communication”, “Data”, “Image”,
“Action”, “Interface”, “Operation”, “Transmission”, “Symbology”, “Device Info” and
“Acknowledgement”. The following table shows all available commands for scanner.
In Action Group, there are ten special commands (Available for Wi-Fi L & F Series) which are
used to remote control the scanner to display a user defined message, to beep, to vibrate, etc.
Remote Control commands include Paging, Remote Indication, Remote Message,
Remote Clear, Remote Lock, Remote Unlock, Remote Programming and Remote
Programming Extension.
Important: For better use of Wi-Fi L & F Series Scanner, we introduced the concept of
Programming Mode, which refers to an occasion where scanner is permitted to perform all
the commands. However, Remote Control listed above is permitted on any occasion, which
means scanner can only perform Remote Control when it is not in Programming mode
. So if
you want to set or get parameters to or from the scanner, you need to put it into Programming
Mode using Remote Programming (Enter) or Remote Programming Extension (Enter)
command. If not, the scanner will reject all the commands (except Remote Control) and
replies a Device NAK. Once entered the Programming Mode, a lock message will be shown
on the screen and the subsequent programming commands will all take effect. After the
operation, you need to send Remote Programming (Exit) or Remote Programming
Extension (Exit) to exit the mode.
（
to be continued
）
Functional
Group
Command Name Supported Scanner
Message
Source
Get/Reply Connected MAC Bluetooth Scanners Host/Device
Get/Reply Paired MAC Bluetooth Scanners Host/Device
Select/Deselect By MAC Bluetooth Scanners Host/Host
Communication
Select/Deselect By ID Bluetooth Scanners Host/Host
Decode Data All Series Scanners Host
Data
Transmit Record Wi-Fi Scanners Host
Enter Capture Image Mode Tethered Scanners Host
Exit Capture Image Mode Tethered Scanners Host
Capture Image Ready Notify Tethered Scanners Host
Image
Get Capture Image Data Tethered Scanners Host