Cino FA470 - Manual (Page 23)

Command Descriptions
2-8
Select By ID
(BT)
Descriptions
Use the auto-assigned ID number to select the desired scanner to communicate
This command is useful when multiple scanners are connected to the SmartCradle in PICO mode.
Afterwards, all the subsequent serial command will be send to this selected scanner, and the other
scanners will not be able to communicate with the host until a Deselect By ID command is sent.
Available for F, L & A series
Packet Format
Prefix Opcode Status Length Parameter LRC Suffix
7Eh 95h FFh FFh 00h 00h 05h See Below Variable 7Eh
1 Byte 3 Bytes 1 Byte 2 Bytes 5 Bytes 1 Byte 1 Byte
Parameter
First and the only Parameter
PID Size Options
FFh 01h 00h 01h (Scanner’s ID)
2 Bytes 2 Bytes 1 Byte
. Host Requirements
If the device successfully received the above command issued by the host, a “Device ACK” will send to
the host right after the device performed the action. Otherwise, a “Device NAK” will be sent to host to
issue a command error. However, if the host can not receive any response from the device within the
user preset time-out duration, please resend the above command.
. Length
Total size (bytes) of the Parameter(s) field
. LRC
”Opcode” XOR “Status” XOR “Length” XOR “Parameter(s)”
. Size
Total size (bytes) of the Options field