Cino FA470 - Manual (Page 70)

Command Descriptions
2-55
Reply USB COM
(TS, SE, FM)
Descriptions
Reply the desired one or more parameters of the USB COM Interface settings
Reply USB COM is sent by the device in response to the Get USB COM command. It sends the
values for all the desired parameters requested in the Get USB COM command.
Available for F, L & A series; SE380, SE390 & SE480 series; FM480 & SM380 series; FA470 &
SM5700 Series
Packet Format
Prefix Opcode Status Length Parameter(s) LRC Suffix
7Eh 04h 00h 03h 00h Variable See Below Variable 7Eh
1 Byte 3 Bytes 1 Byte 2 Bytes Variable 1 Byte 1 Byte
Parameter(s)
First Parameter ……… Last Parameter
PID Size Options ……… PID Size Options
2 Bytes 2 Bytes Variable ……… 2 Bytes 2 Bytes Variable
See Next Page
. Host Requirements
Since Reply USB COM is a device-to-host message, there is no response for this message.
. Parameter(s) Field
Set USB COM can change multiple parameters at one time, so it takes compound parameters.
. Length
Total size (bytes) of the Parameter(s) field
. LRC
”Opcode” XOR “Status” XOR “Length” XOR “Parameter(s)”
. Size
Total size (bytes) of the Options field