Cino FA470 - Manual (Page 150)

Command Descriptions
2-135
Parameter(s)
< Table 6-3-3 > Reply FS Operation Parameter(s) Field (Continued)
Parameter / PID / Size Options Descriptions
OK/NG Active Signal Control
PID : 20h 01h
Size : 00h 03h (3 Bytes)
1
st
Byte
- 00h
- 01h
- 02h
- 03h
2
nd
Byte
- 00h
- 01h
- 02h
- 03h
3
rd
Byte
- 01h
- 02h
- 03h
- 04h
- 05h
- 06h
- 07h
- 08h
- 09h
- 0Ah
- XXh
OK/NG Active Signal Output
Disable
Enable NG only
Enable OK only
Enable*
OK/NG Active Signal State
OK Low/ NG Low*
OK Low/ NG High
OK High/ NG Low
OK High/ NG High
OK/NG Active Duration
10ms
20ms
30ms
40ms
50ms
60ms
70ms
80ms
90ms
100ms *
User-defined (See Note under the table)
OK/NG Beep Control
PID : 20h 02h
Size : 00h 02h (2 Bytes)
1
st
~2
nd
Byte
- 00h 00h
- 01h 01h
- 00h 01h
- 01h 00h
Disable
Enable *
Enable OK only
Enable NG only
Scan Input Time-out
PID : 20h 03h
Size : 00h 01h (1 Byte)
- 00h
- 01h
- 02h
- 03h
- 04h
- 05h
- 06h
- 07h
- 08h
- XXh
100ms
200ms
300ms
400ms
500ms
600ms
700ms
800ms
900ms*
User-defined (See Note under the table)
. Notes
1. OK/ NG Active Duration can be set to User-defined 1~99(×5) milliseconds. XXh = desired
milliseconds (h) + 80h. For example, if you want to set it to 99 (×5) ms (the actual value is 495 ms),
you need to convert 99 from Dec to Hex, that is, 63h. Then, XXh = 63h + 80h = E3h.
2. Scan Input Time-out can be set to User-defined 1~99 seconds. XXh =desired seconds (h) + 80h.
For example, if you want to set this parameter to 99 seconds, you need to convert 99 from Dec to
Hex, that is, 63h. Then, XXh = 63h + 80h = E3h.