ADLINK Express-HL2 - Manual (Page 50)

Page 50 Express-HL2
Feature Options Description
AIN0 Read only Display actual voltage of AIN0
V3 . 30 Read only Display actual voltage of 3 . 30 V
V1 . 05 Read only Display actual voltage of 1 . 05 V
V3 . 30 Read only Display actual voltage of 3 . 30 V
V1 . 35 Read only Display actual voltage of 1 . 35 V
V5 . 00 Read only Display actual voltage of 5 . 00 V
VIN Read only Display actual voltage of VIN
AIN7 Read only Display actual voltage of AIN7
7.2.4.4 System Management > Runtime Statistics
Feature Options Description
Runtime Statistics Info only
Total Runtime Read only The returned value specifies the total time in minutes the system
is running in S0 state
.
Current Runtime Read only The returned value specifies the time in seconds the system is
running in S0 state
.
This counter is cleared when the system is removed from the
external power supply
.
Power Cycles Read only The returned value specifies the number of times the external
power supply has been shut down
Boot Cycles Read only The Bootcounter is increased after a HW- or SW-Reset or after a
successful power-up
.
Boot Reason Read only The boot reason is the event which causes the reboot of the
system
.
7.2.4.5 System Management > Flags
Feature Options Description
Flags Info only
BMC Flags Read only
BIOS Select Read only Display the selection of current BIOS ROM .
ATX/AT-Mode Read only Display ATX/AT-Mode .
Exception Code Read only System exception reason .