Datavideo MP6000MD - Manual (Page 15)

14
Quick Start Guide:
As the heading suggests, this is the quick start section. If you require more detailed operating
instructions please go to page 18.
Step 1: Turn on power to the MP­6000MD, the source and the monitor.
Step 2: Press the “POWER” button, to turn on the MP­6000MD. The word “MP­6000” and then
“BOOT” will appear on the display window. After a couple seconds, it will present “NO Disc”
that means the tray is empty. Please place a disc on the tray.
Note: The upper right window on the TV screen will show two lines of data. One is the
status of the unit, the other one is the input format setting.
Step 3: Press the “EJECT” button once, the tray will come out, the word “OPEN” appears in the
window. Please put the DVD+R or RW disc with the printing surface up, and then press the
“EJECT” button again. The tray will return into the MP­6000MD.
Step 4: The word ' Reading ' appears on the screen, in the upper right corner; this means the
MP­6000MD is reading the disc. If the disc contains previous recordings, it will be detected
during the read process. If there is a recording present you can press the “PLAY” key and play
out the program immediately.
Step 5: If it is a blank/brand­new disc, the MP­6000MD will start the formatting process
immediately. A window will appear saying “FORMATTING.” The entire process will take
approximately 20 second.
Note: It’s necessary to format the disc before you start recording.
Step 6: Find the “VIDEO INPUT” under the MENU button to choose the input signal source.
Step 7: Find the “VIDEO STANDARD” under the MENU button to choose the proper video
standard, NTSC or PAL.
Step 8: Find the “RECORD QUALITY” under the MENU button to choose HQ / SP / LP / EP / SLP
record quality. Once this is set you can start recording.
Step 9: Before you start to record, you can adjust video input source quality by using the color
processor of the MP­6000MD.