Aiphone ROAMER WP100A - Manual (Page 9)

7 OPERATIONS
The WP100A Reamer System connects the ANA9500 cordless phone to the paging and
intercom system, as well as to the facility’s telephone system. The cordless phone allows
full roaming capabilities for the manager or person most needing to be in communication
with people both inside and outside the building.
TELEPHONE SYSTEM:
The WP100A connects the ANA9500 to the telephone, paging, and intercom systems. The
WP100A has three inputs to provide major functions.
1. When a hardwired extension in the phone system calls the ANA9500: Connected
through an analog port on the telephone system, a ring signal is sent to the WP100A.
• If the cordless phone is not busy, it will ring. There are three settings for ring: loud,
soft, and vibration. When the TALK button is pressed, the phone goes “off hook”
and is connected to the incoming call.
• If the ANA9500 is busy with an intercom call, both the cordless phone and
intercom will hear a call-waiting tone. The standard telephone placing the call
will hear a ring-back tone.
2. When an intercom station calls the ANA9500: The ring jumper(s) must be installed on
the WP100A to allow the MarketCom system to ring the cordless phone. (See pg. 3)
• The person at the intercom picks up the handset and selects the designated
channel button.
• If the ANA9500 is not busy, it will ring. When the TALK button is pressed, the
cordless phone is connected to the designated channel on the intercom system.
• If the cordless phone is busy with a standard telephone call, a busy tone will be
heard at the calling party’s intercom.
• If the ANA9500 is busy with an intercom call, both the cordless phone and
Intercom will hear a call-waiting tone.
3. Placing a call from the ANA9500 cordless phone: If no other call is waiting, a go-ahead
tone will be heard when the TALK button is pressed.
• To connect to a standard telephone extension, press “TALK, *”.
• To page, press “TALK, 0”, wait for pretone, then make a page announcement.
• To connect to an intercom channel, press TALK and designated communication
channel (1~4).
• With the TD-H system, the ANA9500 can ring a TD-H phone if wired to do so.
ADVISORY TONES:
During normal operation, the WP100A generates the following advisory tones:
• Go Ahead. Series of three tones sent when the ANA9500 goes off-hook and
there are no calls waiting.
• Paging. Series of five tones sent after the ANA9500 has dialed “0” to access the
PA system, and indicates that a page can now be made.
• Paging Pre-tone. Tone sent over the PA system to indicate that a page is
forthcoming. When using Aiphone’s PG-C series amplifier, the same pretone will be
heard when paging from the intercom or cordless phone, with adjustable volume.