Aiphone ROAMER WP100A - Manual (Page 4)

S TERMINAL FUNCTIONS and ADJUSTMENTS
The WP100A has a 24V AC transformer input, an 8-conductor modular phone jack input,
and a 12-pin terminal connector.
12-pin Connector Terminal Definitions:
The 12-pin connector can be connected to the system wiring while unplugged, then
simply plugged into the slot when wiring is completed.
1 Output to Amplifier (600 ohm balanced input)
2 Output to Amplifier (common)
3 Amplifier output shield (connect shield of 1 & 2 wires)
4 Common or negative
5 Call channel programing (For ring jumpers with MC system)
6 Call channel programing ( “ “ )
7 Call input ring terminal from TD-H system (TD-H system only)
8 Communication line 1 from intercom to phone
9 Communication line 2 from intercom to phone
10 Communication line 3 from intercom to phone
11 Communication line 4 from intercom to phone
12 Ring activation from intercom to cordless phone (MC system only)
VOLUME ADJUSTMENT:
• With a small screwdriver, the volume can be adjusted for the output volume of the page
from the ANA9500 phone. Additional volume adjustments for the paging system can be
done at the paging adaptor and amplifier.
PAGING ADAPTOR AND AMPLIFIER CONNECTIONS;
To connect the Wireless Roamer system to the paging system, use the 600 ohm balanced
input into the paging amplifier. This is usually noted as a “TEL” (telephone) input.
WP100A-------- > MC-A/A
4----------------> 5/.
8~11 —> 3, 4, 6, 7 (For communication)
WP100A-------- > Aiphoine PG-C series Amplifier
1 --------> 1 TEL (Set dip switches 1 & 2 t o ON position)
2 -------> 2 Common
3 -------> 3 (Shield connection)
WP100A--------- > TOA 900 Series with L41S 600 ohm bal. muting module
1 ------- > 3 (Hot)
2 -------> 2 (Common)
3 -------> 1 (Earth, Shield connection)
WP100A-------- > Standard Paging Amplifier (Use muting input if music is included)
1 ------ > 600 ohm balanced, HOT
2 ------- > 600 ohm. Common
3 ------- > Ground (Shield connection)
4