Canon FAX-B155 - Manual (Page 70)

58
Press [Coded Dial] and enter the appropriate
two-digit Coded Speed Dialling code.
Wait a second for the number to appear after the
name of the number.
❚ If no number is registered for the button or code
you pressed, the LCD display shows the NO TEL #
message. Make sure you pressed the correct button
or entered the correct code and that the number
you want to dial is registered correctly.
❚ If you make a mistake, press [Stop]. Then press the
correct One-touch Speed Dialling button or press
[Coded Dial] and re-enter the code.
❚ If an error message appears on the LCD, correct
the error and press [Stop]. If necessary, refer to
Frequently asked questions, p. 106.
❚ The fax beeps once to indicate that the document has been sent successfully.
TRANSMITTING OK
❚ If an error occurs during sending, the fax beeps intermittently for a few seconds. If
this happens, try sending the fax again.
❚ The fax automatically redials if the receiving fax does not answer or if the line is
busy. (You can specify the number of times it redials; see AUTO REDIAL in TX
SETTINGS, p. 87.)
❚ To stop sending before the fax is finished, press [Stop]. You may then need to lift
the operation panel to remove the document. See Clearing document jams, p. 62.
❚ If an error message appears on the LCD, correct the error and then press [Stop].
Refer to Error codes, messages and solutions, p. 112.
Automatic Dialling______________________________
■ Sending a document using One-touch Speed Dialling or
Coded Speed Dialling
After registering the One-touch numbers or Coded Speed Dialling numbers, you can
send documents as follows:
1
Feed the document face-down into the Auto-
matic Document Feeder (ADF).
See Loading the document, p. 49.
You can set the resolution and the density, p. 51.
2
Press the One-touch Speed dialling button
assigned to the number to which you wish to
fax.
or
FINE
10 01
CANON FAX
12345678999
or
Coded Dial
✱
9 0
CANON FAX
12345678999