Aiwa NSX-MT725 - Manual (Page 19)

MUSIC SENSOR
If there is a 4-second or longer blank between each track, a search
for the beginning of the current or next track during playback can
be done easily.
Press ◄ ◄ or ► ► during playback referring to the playback side
indicator (◄ or ► ) on the display.
For example, when ► ► is pressed while ► is displayed, playback
of the next track starts.
Music sensor function may not be able to detect tracks under the
following conditions:
• Blanks of less than 4 seconds between tracks
• Noisy blanks
• Long passages of low-end sound
• Low overall recording levels
CONTINUO
I.
About cassette tapes
• To prevent accidental erasure,
break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
Side A
Type II tape
detection
slot
Tab for side A
To record on the tape again, cover the tab openings with
adhesive tape, etc. (On Type II tapes, take care not to cover
the Type II tape detection slot.)
■ 120-minute or longer tapes
are extremely thin and easily
deformed or damaged. They are not recommended.
' Take up any slack in
the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism.
O
GQ
<
IX
u
DL
<
Ih
After playback on one deck finishes, the tape in the other deck
will start to play without interruption.
1 Insert tapes into deck 1 and deck 2.
2 Press TAPE/DECK 1/2 to select the deck to be
played back first.
3 Press REV MODE to select
4 Press to start playback.
Playback continues until ■ is pressed.
ENGLISH
19