General there is no sound, Tuner î5ection, Cassette deck section the tapei does not run – Aiwa NSX-V2100 User Manual
Page 17: Cd player section the cd player does not play, To reset, Troubleshooting guide parts index
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLESHOOTING GUIDE
PARTS INDEX
If the unit fails to perform as described in these Operating
Instructions, check the following guide.
GENERAL
There is no sound.
• Is the AC cord connected properly?
• Is there a bad connection? (-» page 3)
• There may be a short circuit in the speaker terminals.
Disconnect the AC cord, then correct the speaker
connections.
• Was an incorrect function button pressed?
Sound is emitted from one speaker only.
• Is the other speaker disconnected?
An erroneous display or a malfunction occurs.
-» Reset the unit as stated below.
TUNER Î5ECTION
There is constant, wave-like static.
• Is the antenna connected properly? {-* page 3)
Change the orientation of the antenna.
The reception contains noise interferences or the sound
is distonted.
• Is the system picking up external noise or multipath distortion?
Change the orientation of the antenna.
-* Move the unit away from other electrical appliances.
CASSETTE DECK SECTION
The tapei does not run.
• Is a deck in pause mode? (-» page 9)
The sound is off-baiance or not adequately high.
• Is the playback head dirty? (-► page 15)
Recording is not possibie.
• Is the erasure prevention tab on the tape broken off? (-► page
12
)
• Is the recording head dirty? (-» page 15)
Erasure is not possible.
• Is the erasure head dirty? (-* page 15)
• is a metal tape being used?
High frequency sound is not emitted.
• Is the recording/playback head dirty? (-* page 15)
CD PLAYER SECTION
The CD player does not play.
• Is the disc correctly inserted? (-► page 7)
• Is the disc dirty? (-► page 15)
• Is the lens affected by condensation?
-» Wait approximately one hour and try again.
Instructions about each part on the main unit or remote control
are indicated on the pages listed below.
To reset
It an unusual condition occurs in the dispiay window or the
cassette decks, reset the unit as follows.
1 Press the POWER button to turn off the power.
2 Press the POWER button while pressing the ■ CLEAR button.
Everything stored in memory after purchase is canceled.
If the power cannot be turned off in step 1 because of a
malfunction, reset by disconnecting the AC cord and repeat step
2
.
<
QC
Ul
Z
lU
U
(in alphabetical order)
Parts
□
Pages
CD
4, 7
■ CLEAR
6, 7
GRAPHIC EQUALIZER (ROCK/POP/JAZZ) 5
DISC CHANGE
7
DISC DIRECT PLAY (1,2, 3)
7, 10, 11
± OPEN/CLOSE
7
PHONES
5
POWER
4
► PRESET
6, 7
II SET
4, 6, 7
TAPE
4, 9
T-BASS
5
TUNER/BAND
4, 6
►► TUNING (!◄◄ DOWN>W UP) 4, 6, 7
VIDEO/AUX
4, 14
VOLUME
5
□
Deck 1,2 operation buttons
9, 10, 11
B
BAND (+10)
6
■ CLEAR
6, 7
CLOCK (9)
4
DISC DIRECT PLAY (1,2, 3)
7, 10, 11
EDIT/CHECK(1)
7, 10. 11
FUNCTION
4
GEO (4)
5
MONO/TUNER (0)
6
► PRESET
6, 7
PRGM (2)
8
RANDOM/REPEAT (3)
8
II SET
4, 6, 7
SHIFT
4
SLEEP (8)
12
T-BASS (6)
5
TIMER (7)
13
►► TUNING (!◄◄ DOWN/W UP) 4, 6, 7
VOLUME (y\, N/)
5
0-9, +10
6, 7, 10, 11
ENGLISH
16