Preset number tuning, 1 press the tuner/band button to select a band, Selecting a preset number on the main unit – Aiwa NSX-AV800 User Manual
Page 10: About cassette tapes, Dolby nr system, Inserting tapes, To select a reverse mode (deck 2 only), Basic operations 2 1
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TAPE PLAYBACK
PRESET NUMBER TUNING
BASIC OPERATIONS
2
1
Use the remote control to select the preset number directly.
1
Press the TUNER/BAND button to select a band.
2
Press the numeric buttons to select a preset
number.
Example:
To select preset number 25, press the +10, +10 and 5 buttons.
To select preset number 10, press the +10 and 0 buttons.
Selecting a preset number on the main unit
Press the TUNER/BAND button to select a band. Then, press
the DIRECTION/PRESET button repeatedly.
Each time the button is pressed, the next highest number is
selected.
About cassette tapes
• To prevent accidental erasure,
break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
Side A
Type II tape
detection
slot
To record on the tape again, cover the tab openings with
adhesive tape, etc. (On Type II tapes, take care not to
cover the Type II tape detection slot.)
' 120-minute or longer tapes
are extremely thin and easily
deformed or damaged. They are not recommended.
' Take up any slack in
the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism.
DOLBY NR system
The Dolby Noise Reduction system reduces tape hiss noise.
For optimum performance when playing back a tape
recorded with the DOLBY NR system, turn on the DOLBY
NR system.
■ Deck 2
INSERTING TAPES
• On deck 1, tapes are always played back on both sides.
On deck 2, you can select a reverse mode to play back one or
both sides.
• Use Type I (normal), Type II (high/Cr02) or Type IV (metal)
tapes for playback.
Press the TAPE button and press the ± EJECT mark
to open the cassette holder.
Insert a tape with the exposed side down. Push the cassette
holder to close.
To select a reverse mode (deck 2 only)
Each time the REV MODE button is pressed, the reverse mode
changes.
Ur
)->cr)
To play one side only, turn on Z.
To play from front side to back side once only, turn on TO.
To play both sides repeatedly, turn on C l').
•
When tapes are loaded in both decks, ~ Z ) in the display
indicates Continuous Play.
9
ENGLISH