SINGER 610U User Manual
Page 30
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Applique adds beauty and interest to clothes and
household linens. Either contrasting or self fabric can
be used effectively.
The stitch most commonly used in appliqueing is
basic pattern
J
closely spaced to form a satin stitch.
The width of this and other basic patterns can be
varied to accommodate fabrics of different weaves and
textures. Combination patterns and variations can also
be used to applique with decorative stitching.
To prepare for appliqueing, make a sample to help
you decide which of the following two methods is the
more appropriate for your fabric and design.
• Position the design.
• Baste it to the fabric.
• Attach Special Purpose Presser Foot
(and General Purpose Throat Plate).
Method
1.
Set Stitch Pattern and Stitch Width Selectors for
desired applique stitch. Set Stitch Length Regula
tor on
FINE
(above
20).
2. Stitch, outlining the design with applique stitching.
3.
Trim any excess fabric on the outer edges of the
stitching. Remove basting.
Method ^2
1. Adjust selectors for straight stitching
(AN 3).
2. Outline the entire design with a short stitch.
3. Trim raw edges to the stitching.
4.
Readjust selectors for stitch pattern and width desired,
and set Stitch Length Regulator on
FINE.
5.
Stitch,
following
the
straight-stitch
outline.
This
step will produce a smooth overedged finish, with
no raw edges to be trimmed. Rernove basting.
CORDED APPLIQUE
The Special Purpose Foot, which provides for a filler
cord is most suited for corded applique work. Gimp,
crochet thread, etc. are generally used for filler cord.
Follow either Method #1 or #2, described above.
The only difference in corded applique is the introduc
tion of the cord, over which the applique stitching is
formed.
To Threod Filler Cord
1. Place the spool of filler cord on the table, floor, or
in your lap.
2. Unw’ind a suflicient amount to avoid tension or
strain on the cord.
3. Lead the end of the cord through the eyelet in front
center of the Special Purpose Foot.
4. Draw the cord under and in back of the foot.
5. Proceed with stitching as for regular applique stitch.
28